Pirate4x4.Com : 4x4 and Off-Road Forum - Reply to Topic
 
Pirate4x4.Com : 4x4 and Off-Road Forum  

Go Back   Pirate4x4.Com : 4x4 and Off-Road Forum > General Tech > General 4x4 Discussion > Ruffstuff Y link tierod roll
Notices

Thread: Ruffstuff Y link tierod roll Reply to Thread
Title:
  
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now

In order to be able to post messages on the Pirate4x4.Com : 4x4 and Off-Road Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.

** A VERIFICATION EMAIL IS SENT TO THIS ADDRESS TO COMPLETE REGISTRATION!! **

Email Address:
Insurance
Please select your insurance company (Optional)

Log-in


Additional Options
Miscellaneous Options

Topic Review (Newest First)
02-21-2020 05:39 AM
sylvia.kov2002
Quote:
Originally Posted by Mr.RatBastard View Post
I am putting together a early bronco with full width axles out of a 1978 F-150. Iam getting close to putting the steering on. I ordered a Ruffstuff 1 ton GM Y link kit. All good until a friend reminded me he used this setup on a Cherokee and never could get it to drive right and ended up taking it off switching to crossover.
He had a problem with tie rod roll. I started researching it and Ruffstuff sells "the cure" so the problem is real. Why didn't they include it? Anyway before I start cutting and fitting I want to know how likley is it I will have a problem? Will the cure fix it if I do? Should I do something different? If so what?
3.5" lift, 35's-37's, Toyota pwr steering box.
I had "The cure" installed on it and it was fine. I removed it to see if there was a difference. I didn't notice any difference and just left it off.
02-14-2020 01:26 PM
desertCJ I see. I ran that setup with 3/4"x 5/8" hiems before as well. Just have to keep an eye on that nut/bolt, make sure it stays tight. You may run out of angle on the drag link hiems depending on your setup. It worked fine for me though.
02-14-2020 12:51 PM
Mr.RatBastard
Quote:
Originally Posted by desertCJ View Post
Cross over is fine but isn't it going to cost you a high steer arm and hardware? Is the passenger side knuckle already setup with studs?
I would mount the drag link on top and tie rod on bottom of the knuckle.
02-14-2020 11:19 AM
Topar174 I used the one ton set up and the cure on my Dodge, it never worked well for me. I think the Y link is just a poor design. I switched to Ruff Stuff crossover with all hiems and love it, big difference!
02-14-2020 10:27 AM
desertCJ Cross over is fine but isn't it going to cost you a high steer arm and hardware? Is the passenger side knuckle already setup with studs?
02-14-2020 06:24 AM
Mr.RatBastard
Quote:
Originally Posted by desertCJ View Post
Keep the Y link. You don't even know if you have a problem right?
Correct but since I haven't cut or installed anything it wouldn't cost anything to switch to crossover style now if there is less chance of having a problem.
02-14-2020 06:08 AM
desertCJ Keep the Y link. You don't even know if you have a problem right?
02-14-2020 05:27 AM
Mr.RatBastard Ruffstuff said they would swap out the tre's for heims. The new problem that would create is at least 6" difference in length between my track bar and drag link. Keep the Y link, switch to crossover? Any other suggestions?
02-13-2020 07:36 AM
RANGERROD Iíve seen with and without the cure. I know in my friends tj it made a difference since the drag link was at such a steep angle. I think it would roll the tie rod up and down because of this. I imagine if it was more parallel to tie rod you wouldnít see this roll. If that makes sense.
02-13-2020 05:18 AM
_Stucky My experience with the cure is that I couldnít get the tierod end to seat fully. My truck drives fine with ruffstuff y link and no cure. Personally I think itís a snake oil type thing.
02-12-2020 02:00 PM
desertCJ I think that the distance front to back from the pitman arm to the tierod connection point being longer than necessary would cause it to be worse.

Edit: Keep the drag link as close as parallel to the tiered while still having clearance as possible.
02-12-2020 09:29 AM
Mr.RatBastard I agree my friend could of had other issues that contributed to the problem. I know Ruffstuff didn't invent Y link steering but I think they did patent the cure even though Ford had something similar way back when. There must be a issue or they wouldn't sell the cure.
The big question is what causes it so I can avoid it? Too much angle on the drag link or misalignment of the drag link and tie rod(from the top looking down) or more basic parrellel drag link and track bar close to parrellel as possible not being good?
02-12-2020 08:18 AM
desertCJ I had that same steering setup on my Cherokee. I had "The cure" installed on it and it was fine. I removed it to see if there was a difference. I didn't notice any difference and just left it off.
02-12-2020 08:08 AM
welndmn This is not a Ruffstuff issue, but an issue with all Y style steering.
Yes, the Cure takes a lot of loose feeling out of the steering.
Your firend that never got it right, I'm guessing had some other issue. People have been driving with Y style steering for years.
02-12-2020 06:22 AM
Mr.RatBastard
Ruffstuff Y link tierod roll

I am putting together a early bronco with full width axles out of a 1978 F-150. Iam getting close to putting the steering on. I ordered a Ruffstuff 1 ton GM Y link kit. All good until a friend reminded me he used this setup on a Cherokee and never could get it to drive right and ended up taking it off switching to crossover.
He had a problem with tie rod roll. I started researching it and Ruffstuff sells "the cure" so the problem is real. Why didn't they include it? Anyway before I start cutting and fitting I want to know how likley is it I will have a problem? Will the cure fix it if I do? Should I do something different? If so what?
3.5" lift, 35's-37's, Toyota pwr steering box.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -7. The time now is 01:19 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 ©2011, Crawlability, Inc.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.