[22re] [1990 pickup] Wire configuration - Pirate4x4.Com : 4x4 and Off-Road Forum
 
Pirate4x4.Com : 4x4 and Off-Road Forum  

Go Back   Pirate4x4.Com : 4x4 and Off-Road Forum > Brand Specific Tech > Toyota - Truck and 4Runner
Notices

Reply
 
Share LinkBack Thread Tools Display Modes
Old 02-12-2020, 09:51 PM   #1 (permalink)
Registered User
 
Join Date: Jul 2019
Member # 870284
Location: Los Alamos, NM
Posts: 21
[22re] [1990 pickup] Wire configuration

I removed my battery and took out my shitty lugs and I can't remember which wires went to which lug. Positive or negative? The way I have it now I'm just melting ground cables so it can't be right. The only thing I have connected to negative battery terminal is my fender ground. And everything else is on the positive. I have zero knowledge of electrical systems and I wanted to post this in the noob section but apparently you can't access it from a mobile device, so any information I'll be grateful for.
sethsource is offline   Reply With Quote Quick reply to this message
Old 02-12-2020, 09:53 PM   #2 (permalink)
Registered User
 
Join Date: Jul 2019
Member # 870284
Location: Los Alamos, NM
Posts: 21
I've looked everywhere for like information on which cables to attach to the battery and where but I can't find any. I'm probably just retarded
sethsource is offline   Reply With Quote Quick reply to this message
Sponsored Links
Old 02-12-2020, 09:55 PM   #3 (permalink)
Registered User
 
Join Date: Aug 2012
Member # 225201
Location: Can Almost See Fordyce From Here
Posts: 3,422
Are you asking if the positive battery cable goes to the starter from the plus sign thingy on the battery and the negative to ground?

That’s the red one.

By “LUG” do you mean Battery Terminal?

No need to add “I don’t know anything about electrical” at this point.
erictylers1 is offline   Reply With Quote Quick reply to this message
 
Old 02-12-2020, 10:05 PM   #4 (permalink)
Registered User
 
Join Date: Jul 2019
Member # 870284
Location: Los Alamos, NM
Posts: 21
Quote:
Originally Posted by erictylers1 View Post
Are you asking if the positive battery cable goes to the starter from the plus sign thingy on the battery and the negative to ground?

That’s the red one.

By “LUG” do you mean Battery Terminal?

No need to add “I don’t know anything about electrical” at this point.
All of my cables that are supposed to plug into the battery are black. The fender ground is black, the 2 cables coming from the harness are black. Except for the blue cable coming from the fuze box, that's blue. I'm asking, out of these cables (ground connected to fender, fuze box blue cable that's connected to the 80amp fuze I think, and the two thick guaged cables coming from the harness) which of those do I put on which battery terminal?
sethsource is offline   Reply With Quote Quick reply to this message
Old 02-13-2020, 12:15 AM   #5 (permalink)
Registered User
 
Join Date: Feb 2020
Member # 880150
Posts: 2
IF I were a betting man, I would say any black, heavy gauge wire would go to the negative terminal.
One way to be sure would be to measure for continuity between either black wire out of the bundle to a good ground. The engine block, the body (a bare, clean, metal spot), or maybe even the head. As long as you use a good, clean, bare metal location to test for continuity to ground. Get even a cheapo multimeter, like from Harbour Freight, set it to OHMs and put one lead on the point you choose to use for ground, and one on the terminal of the black wire in the bundle. If it reads 0 ohms, or close to, on the lowest ohm scale, it should go to the negative battery terminal.
You should have a pretty heavy gauge red wire on the positive terminal that goes straight to the starter, I believe. I used 4 gauge, I think it was when I replaced mine. Maybe 1-0 . It sounds like the blue wire that goes to the underside of the 80 amp fuse is the fusible link wire that feeds the fusebox in the engine compartment. From that wire, all the truck's electrical systems get their power, through the individual system fuses.
I used a pair of 8 Gauge wires from the negative terminal, one to the side of the fender (body ground) and one to the place the engine grounds to, the AC bracket.
There should be four more ground spots, one that goes from the firewall to the engine hoist hook on the rear driver's side, basically it grounds the head(s), one from the alternator to the PS pump bracket, one in the intake manifold that has two bundles in one big terminal, under one of the intake manifold attachment nuts, and one in the passenger compartment, behind the driver's side kick panel, behind the fuse box there.
The only two that actually go to the battery directly though are the one to the fender well just in front of the battery, and the one down to the engine. If there's no AC compressor or bracket, there are a number of places near where it would go that you can attach a good sized ring terminal to the engine.

These are all on the 87 4Runner. Your Mileage may vary

Last edited by PhantomTweak; 02-13-2020 at 12:25 AM.
PhantomTweak is offline   Reply With Quote Quick reply to this message
Old 02-13-2020, 06:12 AM   #6 (permalink)
Registered User
 
Join Date: Mar 2001
Member # 3886
Location: southern oregon
Posts: 4,935
Just because a wire is black DOES NOT mean it is a ground.

OP learn some electrical theory or find someone who knows wtf they are doing before you burn your shit down
__________________
hold this...
gnob is offline   Reply With Quote Quick reply to this message
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Pirate4x4.Com : 4x4 and Off-Road Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.

** A VERIFICATION EMAIL IS SENT TO THIS ADDRESS TO COMPLETE REGISTRATION!! **

Email Address:
Insurance
Please select your insurance company (Optional)

Log-in


Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 08:42 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 ©2011, Crawlability, Inc.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.