Pirate 4x4 banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 7 Results
  1. General 4x4 Discussion
    What's up everybody just joined, been reading for a while. I want to build a fuso box truck, rip the box off and make a custom camper on the back. where you lads come in is what axles do I put under it. I plan on using 41" goodyears and need at least 6k front and 10k rear rating. its gonna get...
  2. Jeep - Non Hardcore
    Hey guys this is my 1st post. I have a 93 YJ 350 SBC swap TH400 D20 D44 F&R scout rear, wagoneer front. My driveshaft seems to have alot of play at the union where the 2 pcs slip together (not sure what this is called 🤔) I assume there is a bushing blown out in there? Possibly caused by the...
  3. General 4x4 Discussion
    Hello everyone, I'm building a 4x4 58 Chevy Viking crew cab and bought what I thought would be the perfect axle for the project. It's a Dana/Spicer model 70 front drive axle, open knuckle. I'm trying to find out what vehicle it came from so I can find parts easier. According to the stamp I think...
  4. Chevy
    I have a 1989 k1500 5speed. It runs fine getting on it but never will idle. I have no idea what to do. I have replaced fuel filter, dumped tank, Iac,Tps, egr, map, and ignition relay and even the Ecu/Ecm and the prom chip. Please help I have no vehicle sometimes
  5. General 4x4 Discussion
    I have a gm 93 nv4500 that I replaced the bearings and synchros in. I swapped it into my 86 square body and have been driving it about 3 days no trouble. Took it on the interstate for the first time last night and when I got off the exit I could not shift into second. I played with it the rest...
  6. General 4x4 Discussion
    Hi, I have a dodge Dana 60 kingpin, I’m trying to install 5.38 gears and a 4.56 and up ox into it. I started with regular gear set and found that I could spin the carrier freely without it making contact with the pinion. I ordered thick 5.38s. Doing this I was able to get the ring gear to make...
1-6 of 7 Results
Top