I've got a YJ front Dana 30 with 4.56's, ARB G2 inner and USA standard outer Cro-Mo shafts. This axle is set up for spring over and has the M.O.R.E. high steer kit. Comes with tie rod and Drag link. I was told the whole setup has about 15-20k miles on it.
It also comes with an XJ HP 30...
i’m in the middle of an aw4 swap to my 4.0 HO YJ, i got a wintershifter and the control kit from Radesign.
How can i locate the solenoid wires? Is there any other surprises should i expect (flexplate, cranshaft sensor…)?
I’m trying to make this build work. So i swapped the ax-15 for an aw4 from a Cherokee, shortened the rear driveshaft but it wouldn’t drive.
I’ve read that I needed standalone shifters and radesign shifters.
Can someone guide me through it? Thank you!