Pirate 4x4 banner
1 - 3 of 3 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 · (Edited)
Trans planting a 02 Vortec out of a S10 Blazer in to my Flattie. The problem I ran into is the trans(Th350) bolted up fine to the engine but the torque converter is about a .50" away from the flexplate (used an earlier s.b. Gm flexplate for correct bolt pattern). Anybody ran into this or have any advice? Thanks in advance. C
 

·
Registered
Joined
·
30 Posts
Discussion Starter · #4 ·
Some people have recommended spacers. Anyone have any input on them? Would it throw the motor/trans out of balance? Thanks
 
1 - 3 of 3 Posts
Top