Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
I was looking in one of my grandpas barns for some scrap steel and found one monster of a winch. Turns out its a 20,000 lb. Low Mount Garwood Winch. It got a bit of surface rust but im sure the internals are ok. I was just wondering if anybosy on here would know where to get parts for these things.

Also Is there any way I can use a pto drive from an NP435 to use this winch?

Or would the weight render it useless on a normal sized rig?
 

·
Registered
Joined
·
1,196 Posts
I was looking in one of my grandpas barns for some scrap steel and found one monster of a winch. Turns out its a 20,000 lb. Low Mount Garwood Winch. It got a bit of surface rust but im sure the internals are ok. I was just wondering if anybosy on here would know where to get parts for these things.

Also Is there any way I can use a pto drive from an NP435 to use this winch?

Or would the weight render it useless on a normal sized rig?

Sounds like it would be too heavy for a normal rig. You could make a sweet ass recovery rig or a shop hoist though :D
 
1 - 4 of 4 Posts
Top