Pirate 4x4 banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
19,786 Posts
a 1330 has the least amount of angle when looked at all the other CV's.
I say run a normal shaft, or 1350 CV.
 

·
Registered
Joined
·
129 Posts
Discussion Starter #4
I'm thinking about it but yokes aren't readily availiable for the bw 1356. There is a flange yoke out there that may take a 1350 though.

According to Jesse at HAD you can get 28-30 out of a 1330 cv.
 

·
Registered
Joined
·
381 Posts
believe it or not but i ran 1330 joints on the front of my bronco. i didnt have one busted shaft last year. i am running 39" iroks on 1 tons and a not so light right foot! i dont recommend running 1330's at serve angles but i have no complaints!

oh yea, if its any consolation i just put 1410 shafts/yokes front and rear so i dont have to worry about it any more :smokin:

-cutts-
 
1 - 6 of 6 Posts
Top