Are they all the same?
spindle length?
bearings (id measurements)?
hubs (particularly the placement of the bearings in the hubs)?
year changes that affect one or all of these thing?
Sorry if this sounds like dumbass tech. But have run into a snag on an axle that a buddy bought for his project. It is a RC60 center section with 14 bolt spindles. But the 14 bolt hubs that he bought to use just don't seem to work.
Are there spindles (dana 70, 60 etc.) that are similar but just far enough off to cause grief.
spindle length?
bearings (id measurements)?
hubs (particularly the placement of the bearings in the hubs)?
year changes that affect one or all of these thing?
Sorry if this sounds like dumbass tech. But have run into a snag on an axle that a buddy bought for his project. It is a RC60 center section with 14 bolt spindles. But the 14 bolt hubs that he bought to use just don't seem to work.
Are there spindles (dana 70, 60 etc.) that are similar but just far enough off to cause grief.