Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
Joined
·
4,031 Posts
Im only using 14b hubs on a custom 9" axle. Ive got to get custom shafts anyway and I can get double splined shafts much easier than custom length and splined shafts with a 14b ff flange on the end.

It would be much easier if the bolt circle on the flange were the same as dana axles, but its not, so it limits my options.
use dana 70 hubs on the rear then...they will fit on 14 bolt spindles.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top