Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
16,050 Posts
Discussion Starter · #1 ·
Hi everyone,
I've got what I *think* is a 1980-81 8 lug semi floater from an F250. I was going to have this axle cut down and have 9" ends put on it, and then disc brakes. I don't think the 9" housing end thing is going to be a big deal, but what about using those axle shafts? Will they be able to turn them down and re-drill them to be 5 on 5.5, or will I have to get new 9" axleshafts? Does anyone know off hand if this is a 30 or 35 spline axle? BTW, anyone besides Currie make those housing ends? $75 sounds a little steep.

Thanks in advance,
Bryan
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top