Pirate 4x4 banner

1 - 8 of 8 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1 (Edited)
these dodges are hard to find good lifts for! i want about 6-8 in of lift.has anybody used lifted chevy springs?they are same width and length?And what about the rear it allready sits levle or lower.and it all ready has factery blocks.
chevy rears are the same exept center off set is 2in off.rear ward. i ask about chevy because i have many sets of spings for them. and I would like too see''READ'' what others have done on ther rigs.thanx for replies.



this is a '80 short bed
 

·
Registered
Joined
·
46 Posts
I have an 8 inch superlift under my ramcharger. Got entire lift off of e-bay for 500 bucks. It's only got a 2 inch block in the back because they don't make true 8 inch rear springs for the rear. I love it too.

If you're willing to relocate your spring hangers, any lift springs will work.
 

·
Premium Member
Joined
·
8,196 Posts
Obviously they sit 2" rearward. They use a 9/16" bolt instead of a 5/8" bolt, and the eyes will put the pinion at a different angle. I dont know any specifics past that.

Up front you can use chevy springs too, but once again the eyes are different and will cause some funky caster.
 
1 - 8 of 8 Posts
Top