Pirate 4x4 banner
1 - 8 of 8 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 · (Edited)
Here’s to the start of my 1 ton axle swap all fabrication custom by Justin Mildenberger at Fortitude Fab in Corvallis Montana. Photos in this post are just axle mock up.

Quick rundown of the basics.

Front axle: 05+ Superduty Dana 60
Rear axle: 05 FF GM 14 bolt
Front suspension: 3 link with 14” Fox 2.5 Coilovers
Rear suspension: Chevy 63 springs with 14” Fox 2.0 smoothies

More to come, stay tuned.

Wheel Tire Vehicle Land vehicle Car

Wheel Tire Sky Vehicle Cloud


Tire Wheel Sky Vehicle Car

Wheel Tire Car Vehicle Motor vehicle
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #5 · (Edited)
Nice and tight. Looking at 5” of up travel at 22” frame height. Engine has been raised 1” and frame is being modified. Here’s where she sits at full bump. More pictures to come.
Automotive tire Motor vehicle Hood Tread Automotive lighting

Wheel Tire Car Vehicle Automotive tire
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #7 ·
Little update. Here’s a few shots of what was done with the driver side frame rail to keep the ride height low.
Automotive tire Motor vehicle Tread Automotive exterior Rim

Wheel Tire Automotive tire Motor vehicle Tread
 
1 - 8 of 8 Posts
Top