Pirate 4x4 banner
1 - 1 of 1 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter · #1 ·
Ok I did the search so :flipoff2:

Now for my question.

I am swapping in a 2001 cherokee 4.0 into my 83 CJ. I get no spark. I just tested my Crank sensor and it is bad, so I will get a new one. I was testing the whole deal and found that I have 5V on the signal wire with key on and the sensor plugged in or not. What's up with that? Is that what it should be? The FSM basically tells me squat except how to replace it.

Any ideas.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top