Pirate 4x4 banner
1 - 1 of 1 Posts

·
Registered
Joined
·
281 Posts
Discussion Starter · #1 ·
I am in the process of putting my np231 to The 46Re tranny but I am having problems. I get them together and notice there is a 1/8 gap between the two so I pull it back apart and remove that cover with the sealing ring in it, and then put it back up to see if something was binding..wasn't it So I assume the input might be to long. Well to make it short that is also not it so now I am lost for answers on what could be keeping this from going the whole way together.. Any advice on what to look for would be helpful.:confused:
 
1 - 1 of 1 Posts
Top