Pirate 4x4 banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,448 Posts
Discussion Starter #1
trying to get my 4" studs installed for my high steer arms and spacers...
my question is the studs thread all the way through the knuckles.
is it the wrong thread pitch in the knuckle? what is it supposed to be? i tried both sides of the stud too im guessing your supposed to use the long side so the conical washers have a the shank to compres on ...

another problem i am having is getting the old 3" studs out of the drivers side knuckle...i searched and found a couple tricks on here but they are fawking in there..
 

·
Registered
Joined
·
1,448 Posts
Discussion Starter #2
sorry if its confusing my main question is how do i torque these studs if they thread all the way to the shank on long and short side? arent they suppose to be interference fit??
 

·
Registered
Joined
·
2,349 Posts
No, you can't torque them, The hole goes all the way thru, and is threaded all the way thru, as per your description, and also the same as the ones I have. You can't torque them, obviously. They will torque down when you put the arms, cones and nets on them and tighten them. Install them so a thread or two protrudes thru them, and call them good.

Doug
 
1 - 3 of 3 Posts
Top