Pirate 4x4 banner

1 - 5 of 5 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
Practical CNC plasma table with torch height control and computer(no monitor)

Table was well over $12000 new back in 2005.

The table can handle up to a full sheet a half inch steel.

The table is currently assembled but not hooked up and has not been ran in two years.

Does not come with the plasma cutter(power supply and torch) you can add any handheld plasma cutter to it very easily.

Machine also comes with BobCad for programming purposes.

RJ Lynn
[email protected]
 
1 - 5 of 5 Posts
Top