Pirate 4x4 banner

8 lug 44 ?s

669 Views 7 Replies 5 Participants Last post by  Eric
looking at installing a 3/4 ton chevy 44 up front on my toy. just wondering about aftermarket inner axles and u joints. I know warn and ctm is the combination for the 1/2 ton axles but I looked at the warn site and it seems they only offer shafts for the 1/2 ton axles. will these work in a 3/4 ton 44? what are people doing for these? moser inners or something similar?I searched and couldn't find what I was looking for.
1 - 3 of 8 Posts
The shafts are the same. The only difference, besides the thicker tubes, is the 8 lug hubs and rotors and the caliper brackets. everything else is the same.
Oh, and don't use mosers. Use either warn or superior shafts.
I bought 9/16 studs for my 8 lug stuff. Don't know if they will fit in the 6 lug stuff or not. Got them at autozone for a buck fiddy or so. Ask for ones off an 85 3/4ton suburban...
1 - 3 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.