Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
338 Posts
Discussion Starter · #1 · (Edited)
Doing the manual trans swap with a 3.4 clutch and flywheel, will be doing a 3.4 in the near future...I havent found ANY info on the manual swap in the FAQ or searching. Aside from waiting on a couple parts that I didnt get together already (1 flywheel bolt, speedo sender, t-case shifter). I dont know if Im going to have to hack the floor, but it looks like it will fit through the hole already there for the auto, and from what I have seen of other MT runners (as well as my memory serve) the hole looked the same.
I've already got the pedals in, the clutch master, got the old auto stuff out, and am just waiting on a damn flywheel bolt.
If you have any tips or tricks on this swap Im interested...
 

·
Registered
Joined
·
338 Posts
Discussion Starter · #4 ·
issues

Well when I did the swap I didnt get around to the electrical part... I just took the neutral saftey switch and set it to the park position, then stuffed the tcm up under the stereo... problem solved... figured I would deal with that shit later.... well its later, I want to get it straightened out... I tried to figure out what wire to the ecm I needed to mess with to make the ecm think its in neutral(and thus start), and what I needed to do with the wire to the cruise (ground or positive...), as I have no cruise right now(cruise doesnt work when you're in park!) Anyhow, if you have dealt with this swap before, let me know what you did for this stuff... thanks.
 
1 - 2 of 2 Posts
Top