Pirate 4x4 banner

1 - 2 of 2 Posts

·
Registered
Joined
·
3,276 Posts
Discussion Starter #1
ok bare with me.. this dirt car racer i was talkin with to day told me a ford 9 inch mini spool shaved roughly 1/4 inch would fit inside my dana 60 carrier and lock it up bascially .. is this guy full of shit. or does this have sum truth behind it.. a mini spool for a 9 is like 25 bucks.. compaared to a 220 for a spool for a 60.
so what im asking should i waste my time and money and try this or should i just weld them up till i can afford gears and a spool for my rear end..

im a cheap ass.. what can i say.
 

·
Registered
Joined
·
2,012 Posts
Last I heard Ford Mini spools only came in 28 and 31 spline.
I don't see how you could fit a 30 or 35 spline axle in there unless you had custom junk.
But wouldn't that defeat the cost savings?
Just my $0.02.
Just weld it and be done with it.
 
1 - 2 of 2 Posts
Top