Is it possible to disable the CAD for this axle, and replace the two piece longside shaft to a one piece? Has anybody done this? I did a search and found that this axle is less than desireable from the front D60 Bible due to the CAD and the two piece shafts.
96 Dodeg D60 front
1 - 2 of 2 Posts
Not that I am aware of, at least no easly. Alot of the later Dodge 60's actually are alot like the ford D50 fronts, they run essentially D44 running gear. The dodges also have those Unit Bearings that suck. I am pretty sure the 96 falls under this although it has been awhile since I looked into them. Essentailly people have been giving them away to get rid of them.
I am sure somene will chime in with more accurate info but I think that is the jist of it.
-RJ
I am sure somene will chime in with more accurate info but I think that is the jist of it.
-RJ
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Pirate 4x4
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!
