[noenegdod]

Also these with 3 positions: (again links to follow)

 

[noenegdod]

Not sure if I like it for this application yet (the 3 position)

 

[noenegdod]

to bring it back to the center position you end up with pressure pushing the exposed rod back in

 

[noenegdod]

and relying on an equal amount of pressure extending the internal ram to stop it.

 

[noenegdod]

Im working on this now. The stroke for my shift rails is 0.415" to each detent.

I found these with custom lengths: https://www.bimba.com/Products-and-...-Repairable/Original-Line-All-Stainless-Steel

Also these with 3 positions. Not sure if I like it for this application yet because to bring it back to the center position you end up with pressure pushing the exposed rod back in and relying on an equal amount of pressure extending the internal ram to stop it. it is possible that inertia could carry the ram past center: https://www.bimba.com/Products-and-...e/Non-Repairable/Original-Line-Three-Position

https://www.youtube.com/watch?v=lNvP3TGKJOY