anyone got measurements or a tech drawing of an atlas 2 "shorty".
im looking for:
- legnth from centerline of input to opposite side of case
- overall height of case
- overall legnth of case
- measurement from centerline of input shaft to top of case, and bottom, if its not centered.
- total width from input mounting surface to center of rear output yoke.
ordered ours, and need to start cutting to make room for it.
im looking for:
- legnth from centerline of input to opposite side of case
- overall height of case
- overall legnth of case
- measurement from centerline of input shaft to top of case, and bottom, if its not centered.
- total width from input mounting surface to center of rear output yoke.
ordered ours, and need to start cutting to make room for it.