Pirate 4x4 banner
1 - 4 of 4 Posts

·
Registered
Joined
·
905 Posts
Discussion Starter · #1 ·
I recently posted in a thread that I have an AutoCAD drawing of a Chevy Kingpin Dana 60.

I have decided that before I release this drawing I want to make some changes to it. When I created the drawing, my intention was to use it for suspension design. So all of the tubes, spring pads, hubrotors, and things related to mounting it in a truck were dimensionally correct, but the knuckles were not. I am re-modeling most of the drawing and will post a link to the file here when it is completed.

I should be able to finish it in about a week.

-Chris
 

·
Registered
Joined
·
249 Posts
That is pretty sweet. I haven't played with the AutoCad 3D very much yet, so I haven't tried anything like this yet. Could be a good reason to teach myself!

I know there are some better programs to help figure your roll axis and anti-squat rates, but do with what you got, right!

Nice job!

Dean
 
1 - 4 of 4 Posts
Top