Pirate 4x4 banner
1 - 1 of 1 Posts

· Registered
Joined
·
417 Posts
Discussion Starter · #1 · (Edited)
I have a 1977 with a 232 straight 6. I have 2 bent pushrods(cyl. 2 & 4)

I replaced the radiator and started it up one day. The next day I started it up and it was shaking and really missing. After taking the valve cover off I noticed the rods. I have the rods to replace the bent ones. My question is, it there anything else I should be aware of. What all has to happen in orfer for a rod to bend? I don't want to replace these two only to have them bend again

thanks for any help
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top