Pirate 4x4 banner

1 - 20 of 42 Posts

·
Registered
Joined
·
422 Posts
Discussion Starter #1 (Edited)
Buggy is Sold. Thanks Pirate!!

need to sell my buggy due to medical bills piling up on us and anti rejection meds costs and we need to get this under control. I bought this a little over a year ago tore it down and had the chassis finished up and powder coated and skins wrapped.

BTF Fusion 2 Chassis
5.3L
TH 400 - has 2 rides on it.
Atlas 3.0
Warn RC 9,000 Winch
D60 Front - Chromo Shafts w/super joints, knuckles were plated and cryo'd
Shaved, 5.13 gears, lincoln locked.
14 Bolt Rear - Shaved 5.13 gears, Detroit locker.
Double ended ram, PS pump, Orbital, and all of that was new from Howe. Also has Tilt Steering column and all new hoses.
Double Triangulated front and rear 4 link
14" ORI STX Struts Front
16" ORI STX Struts Rear
Interior floor and trans tunnel have been Rhino lined. Cente Console and Dash have not.
12 Volt Unlimited Panel with the sealed racing switches.
15 gal fuel cell
Swag action packer tote for your tools in the back.
Under rear fender quart oil holders both sides.
LED Rock Lights
Blue LED lights inside
UHMW on skid plates
Tires 43" SXII Stickies on Raceline Wheels. Tires were bought new a yr ago.

Specs
112" WB
20" belly height
72" Overall height
90" Wide Outside to Outside of tires
Approx 4100 lbs
Buggy Fits in my Work & Play Toyhauler which has a 13' 10" length. I do not have to take off tires.

Asking $28k
Anymore specific questions or photos contact me at (337) 322-8581.
Buggy is located in South Louisiana.









 

·
Vertical Limits
Joined
·
5,037 Posts
It should be mentioned that it has over 7" of uptravel on both ends with a 20" belly, flat links at ride height and is made to attack obstacles with aggression. This was my personal buggy before Scott took it and made it all his own. It flat works. Engine/tranny/tcase solid mounted motor mounts and heads, 3 position tcase mounts and independent of the belly. 2 piece front is 1410 and a girdle in case you lose a bearing or joint. Ps pump moved up far enough the upper links stuff above the front damper center line. Heated seats? Full auto meter gauges for everything imaginable. This thing is done right.
 

·
Registered
Joined
·
1,240 Posts
Good luck Scott.
Scott knows his shit and want screw you around great guy. The buggy speaks for itself.
 

·
Registered
Joined
·
422 Posts
Discussion Starter #11
Going Offshore in the morning. I will check posts and emails from time to time. I will not have cell service till Wed.
 

·
Premium Member
Joined
·
240 Posts
What's the WMS to WMS?
What's the outside of tire width?
Wheelbase?
 

·
Premium Member
Joined
·
165 Posts
I recognize the gents in these photos - great people and sick rig!!

Don't sell!!
 

·
Registered
Joined
·
422 Posts
Discussion Starter #15
What's the WMS to WMS?
What's the outside of tire width?
Wheelbase?
Not sure WMS to WMS is, But it is a full width Chevy Axle.

Specs
112" WB
20" belly height
72" Overall height
90" Wide Outside to Outside of tires
Approx 4100 lbs
Buggy Fits in my Work & Play Toyhauler which has a 13' 10" length. I do not have to take off tires.
 

·
Premium Member
Joined
·
240 Posts
wheel mounting surface to wheel mounting surface

and, i saw where you added the other measurements to your orginal post. my bad.

reason for wms, is to understand what a different offset wheel would make over width come to. 83" is max for most enclosed trailers unless you do drive over fenders of some sort.

awesome buggy
 

·
Registered
Joined
·
422 Posts
Discussion Starter #17
wheel mounting surface to wheel mounting surface

and, i saw where you added the other measurements to your orginal post. my bad.

reason for wms, is to understand what a different offset wheel would make over width come to. 83" is max for most enclosed trailers unless you do drive over fenders of some sort.

awesome buggy
Rubitx this is my Touhauler i put it in without taking off my tires. It is tight getting through the door but after that it is all good.

 

·
Registered
Joined
·
422 Posts
Discussion Starter #18
wheel mounting surface to wheel mounting surface

and, i saw where you added the other measurements to your orginal post. my bad.

reason for wms, is to understand what a different offset wheel would make over width come to. 83" is max for most enclosed trailers unless you do drive over fenders of some sort.

awesome buggy
When i get back to the house tues I can get the WMS to WMS for you .
 
1 - 20 of 42 Posts
Top