Pirate 4x4 banner
1 - 6 of 6 Posts

·
Registered
Joined
·
824 Posts
Discussion Starter · #1 · (Edited)
Ok. Checking for interest to see what I can do...
set up as follows:

Fully rebuilt within last 1000 miles
New...
Warn premium hubs
bearings
seals
rotors
pads
Detroit locker
yukon 4.56 gears
parts mike "super" arms
1 ton tie rod ends
Spring over(pad center to center same as chevy axle)
760 u-joints
spicer HD ball joints
Complete set of spare shafts also with 760 ujoints.
tie rod/draglink included.

6 lug chevy/toy pattern. 65" WMS

I have close to $2000 in parts alone into this setup. That isn't factoring in any labor.


Would trade for chevy dana 60(SW) that is in runnable condition or sell for $1400 obo. You can't build it for that price. Axle is in Phoenix, Az. Again, this post is checking for interest. Nothing set in stone until I figure out if it would be worth it to me.
 

·
Registered
Joined
·
256 Posts
If you decide to part it out I'll take the Knuckles, arms, spindles, brake calipers and steering linkage (basically from the knuckles out).
PM me and let me know.
 
1 - 6 of 6 Posts
Top