Pirate 4x4 banner

1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1 (Edited)
Colorado Cage Fabricator needed for NORRA Early Bronco Racer Build

unfortunately my fabricator that was going to build my cage is re-locating and now unable to take on the work. (great opportunity for him)

I am looking for an experienced cage builder somewhere in Colorado to build a cage for an Early Bronco Baja racer for the NORRA race. I have a few feelers out from some previous recommendations but need to secure someone to do quality work, so looking at more recommendations / experiences folks might have.

Thanks!
 

·
Registered
Joined
·
3,366 Posts
I'm in phoenix and have done a lot of roll cages for desert trucks over the years. Tt-motorsports.com

Sent from my SM-G965U1 using Tapatalk
 

·
Rolling Mod
04 Wrangler Unlimited, 67 F100
Joined
·
41,554 Posts
I'm in phoenix and have done a lot of roll cages for desert trucks over the years. Tt-motorsports.com

Sent from my SM-G965U1 using Tapatalk
This guy does good work. Don’t know anybody in CO.
 

·
Registered
Joined
·
2 Posts
If you can get ahold of Brad or Roger Lovell, they should know someone to direct you to. They're in Colorado and race a 68 Bronco I sold them after rolling it a couple years ago in the Mex 1000. Whoever did the age did a nice job.
 
1 - 4 of 4 Posts
Top