Pirate 4x4 banner

1 - 11 of 11 Posts

·
Registered
Joined
·
795 Posts
Discussion Starter #1
These were cut off of a military dana 60 that we parted out. I just cut them about 1" from the weld good shape.

250.00
 

·
Registered
Joined
·
1,218 Posts
Are they king pin or ball joint and what size is the outer axel tube.
If they are what I'm looking for I'll take them.
 

·
Registered
Joined
·
467 Posts
They should be king pin prob off a CUCV wich is mid 80's

-RJ
 

·
Registered
Joined
·
795 Posts
Discussion Starter #9
I gues I took for granted everyone was familiar with chevy 60's. They are kingping off of a cucv with around 10,000 miles so the king pins are not hurt either. The tubes I am going to guess on at 3.125 or there abouts
 

·
Registered
Joined
·
1,218 Posts
If they will work on ford dana 60 king pin knuckles and you have the king pins to go with the C's I'll take them. I will send you a pm wiyh my info.
 

·
Registered
Joined
·
795 Posts
Discussion Starter #11
yep they will work the upper kingpins are the same ford,chevy , dodge, send me a PM . I take paypal or MO
 
1 - 11 of 11 Posts
Top