Pirate 4x4 banner

Chevy Springs?

665 Views 3 Replies 3 Participants Last post by  SeaBass44
How do you Measure for the Chevy srping hangers.
1 - 4 of 4 Posts
From left to right <IMG SRC="smilies/biggrin.gif" border="0"> <IMG SRC="smilies/biggrin.gif" border="0">
We did mine by measuring where the stock center pin is and then making the chevys line up with that. We used a 4" drop hangar too because the chevys give close to zero lift and I didn't want to have to run a block (ended up with a 2.5" one anyway).
Ok A real answer <IMG SRC="smilies/wink.gif" border="0"> I hung a plumb bob from fram to center pin on stockers,left it there took off stocker and lined up chevys, I got 11"s center to center.
<IMG width=320 height=240 SRC="http://www.pirate4x4.com/ubb/uploads/chevy hanger for 63.JPG">

[ 10-12-2001: Message edited by: SeaBass44 ]
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.