Pirate 4x4 banner

1 - 2 of 2 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
Alright, first off is this possible? I'm swapping a Np435/Dana 300 along with a 400sbc. The whole set up sits too high for the Yj crossmember, and i have a crossmember from a cj5 (79) and it appears to have a higher mount location. Any ideas on this would it work...i thought that since th cj crossmember is a few inches narrower i could just extend the sides out. Any advice welcome....alos thought about just going with a flat peice of steel or what would be better??
 

·
Registered
Joined
·
4,104 Posts
you might want to measure because the yj frames are wider so doubt it'll fit without some modification.
 
1 - 2 of 2 Posts
Top