Pirate 4x4 banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,470 Posts
Discussion Starter · #1 ·
my cold start injector stopped working for some reason, i'm guessing a temp sensor or something of the sort, maybe even wiring since i did a efi swap on it(i got a few other things not working, but i'll keep that to myself). so i ran a hot wire to a toggle and straight to the injector. flip it on when cold til it starts, and shut it off. i had it wired like this for about 5 or 6 months, and now the injector stopped working all together. any ideas? am i sending too much power to it? should i put an inline fuse or something? i thought of runnng it to the started switch, that was everytime the truck goes to start it fires, but i think that might make it start harder when its warmed up. let me know what you guys think.
 

·
Registered
Joined
·
1,470 Posts
Discussion Starter · #4 ·
yea, i tried jumping it straight to the battery, and it didn't do anything. i'm sure the injector went bad. its probably cause i left the switch on too long. i for got to turn it off the last time. i was getting out of the truck and accidentally flipped it and didn't realize til morning.
 
1 - 4 of 4 Posts
Top