TornadoTJ Thanks for the helpfull answer. <IMG SRC="smilies/flipoff.gif" border="0">
If you must know I've been looking at a set of axels off a 80's J-20 P/U. If you didn't know it is possible to swap in corp 10 bolt shafts to go from a 8-lug 16" wheel to a 6-lug 15" wheel and bolt pattern. The dana 60 and dana 44 used on the J-20 (post 1974) use the 30 spline 1 5/16" diameter shafts.
Actually, JMac, it was a helpful answer. You don't see anyone swapping in D35's, and when someone asks about fixing them up, the answer is to not waste their money. One never knows who knows the difference between axles. I was passing along to you that 10 bolts are probably not worth the effort. So <IMG SRC="smilies/thefinger.gif" border="0"> right back at you! <IMG SRC="smilies/biggrin.gif" border="0">
10 bolts use different spline counts and shaft diamaeter than 44. Besides to swap from 8 lug to 6 or 5 lug all you need to do is swap the outers The stub shaft, knuckles, and bearing spindles (2 different choices) are all the same.
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!