Pirate 4x4 banner

1 - 7 of 7 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
Does anyone know of crown and pinon fabricators/makers in the states? I'm after a set for a Mazda B2600. There was only ever two ratios offered, 0.44 and 4.8795. The later (4.8795) seem to be rarer than rocking hose poo in OZ so the prices are highly inflated if you can find them. The only other option over here is to buy original which cost around the same at the vehicle :eek:

Nev
 

·
Premium Member
Joined
·
4,526 Posts
what year is it?
 

·
Premium Member
Joined
·
3,297 Posts
i know of a couple guys that make one off's but they run 1600$ a shot if interested PM me and i will get you there numbers
 

·
Registered
Joined
·
2,782 Posts
Nope, B2600 = Mazda chassis. Rear end is of the removeable center section type.
Considering that it is 6 lug and all, why not swap to Toyota axles?
 
1 - 7 of 7 Posts
Top