[4runner]

Searched thru the vendor section and the sale section...who has a set?


need a set to fit Chevy D44 1/2ton plan to run on 89 runner SAS...

 

[ATLRoach]

Parts Mike Carries them all the time and has great customer service.

 

[greasyjeep]

http://www.partsmikeparts.com/

 

[300sniper]

yep, part's mike's arms are sweet. i got my drag and center link from him also with 7/8" gm tre's. can't beet his customer service either.

 

[CronusTRD]

Crane has some beefy ones if you want to pony up the dough

 

[NOODLES]

check ebay, usually you can find them for around 80 a peice, already tapped and machined.

 

[KC_JoNeS]

I got mine from Dunk's Performance on this BB. Then I sent them to Parts Mike to have him mill and tap them. Also, 66CJDean on this board will do the mill and tap.

Have fun. I also bought my arms from SKY.

 

[01Tundra]

Got mine from Parts Mike, awsome product & he really knows his shiat :cool2: . Complete Offroad is another good source for Dana stuff, they always have a good supply of used backing plates as well as new stuff.

 

[Fawk Awph]

got mine from someone on the board and then sent them over to sky mfg for the milling and tapping. they turned out sweet. i grabbed a thick histeer arm from sky and a toyota-chevy axle draglink with the steering box adapter to fit on the draglink. everything was top knotch.

Callen

 

[4runner]

the lh side is flat top, but the right is not...so I would have to buy one and get this one milled...