Pirate 4x4 banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,834 Posts
Discussion Starter #1
Anyone interested in a front D44 High Pinion and matching D60 rear from a 1979 Ford F250? I don't have the truck yet, but can buy the entire truck for 1200.00ish. PM me if you're interested. I would sell them for 1000.00 and part out the rest of the truck. PM me if your interested..

Complete axles with tierods too...brakes were just done.
 

·
Registered
Joined
·
436 Posts
Are these axles built? That's pretty pricey!
 

·
Registered
Joined
·
1,834 Posts
Discussion Starter #6 (Edited)
I know...In fact I will just give out the info. Somebody might want them. This truck is located in Colfax at a small garage off the freeway. Going East get off the freeway at the main Colfax exit...go over the freeway to the left then right at the stop. The garage is on the right about a block up. It is bone stock but basically clean for a truck of that year. The guy would likely take 1-1200.00 for the entire truck. Said it had a new engine too. Good luck to anyone interested. Marlon

I'd take a beer for the info... :)
 
1 - 6 of 6 Posts
Top