Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
982 Posts
Discussion Starter · #1 ·
While removing the spider/side gears from my Dana 44 carrier somehow I managed to break the roll pin. I figured no big deal since I had another 44 carrier laying around. I removed the roll pin from that carrier only to find out it had a crack running down the spine of the roll pin. I tried a 1/4" roll pin and it is a little too big and a 3/16" roll pin falls through the hole. Any ideas as to what size roll pin I might need? I measured the old pins with a dial caliper and they were .232" across by 1.5" long.
 

·
Registered
Joined
·
982 Posts
Discussion Starter · #2 ·
TTT for the day crew
 
1 - 2 of 2 Posts
Top