Pirate 4x4 banner

1 - 8 of 8 Posts

·
Registered
Joined
·
230 Posts
Discussion Starter #3
sry for the long delay in my reply...

its from a 79 f-150

I had my neighbore turn it on a lath to cut the flange off where the studs pass through and its a dull finish
 

·
Registered
Joined
·
230 Posts
Discussion Starter #5
F'n A. You can't weld cast to steel can you? I was hoping to use this for a spindle on my tire carrier.
 

·
Registered
Joined
·
569 Posts
F'n A. You can't weld cast to steel can you? I was hoping to use this for a spindle on my tire carrier.
No problem man, Mine has held up for 2 years carring a 36. welded the hub right to the support. No issues, i even broke welds farther down the assembly due to abuse
 

·
Registered
Joined
·
230 Posts
Discussion Starter #8
so would it be cast steel???

Is there any special steps to take befor/while welding it?

Like heat it up to a certain temp befor laying a bead down.....
 
1 - 8 of 8 Posts
Top