Pirate 4x4 banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,641 Posts
Discussion Starter · #1 ·
I have a Dana 44 rear axle, offset, about 52inches from rear backing plate to opposite plate. Set up for a spring over conversion, pads are 44 inches across I belive, will check. Open. I need a T-90, model 18, seats, underseat gas tank for a M.B. or just about anything else for it! let me know what ya got. Located in Prescott Valley AZ.
 

·
Registered
Joined
·
2,641 Posts
Discussion Starter · #3 ·
not sure. I was given a military flatty, but if I took it I had to take the frame/axles that were sitting next to it. The frame it came off of was a willys cj2a frame, but nothing lined up, not even the spring perches. It seems mabye the previous owner was gonna build up something and kinda threw it under there. The axle appears to be receintly rebuilt..
it is open, not sure what gear ratio. He just put some u bolts around the housing and kinda strapped it lightly to the leaves and let it sit there I guess. I would use it, but it is way to wide for the flatty.
 

·
Registered
Joined
·
2,641 Posts
Discussion Starter · #4 ·
parts for trade dont need to be flatty specific. I just need some seats...preferably some beards in decent shape or just the molded plastic ones..something to sit on that would look decent
 

·
Registered
Joined
·
2,641 Posts
Discussion Starter · #6 ·
I will have to remeasure it then and get the correct length. whatever it is, just about 7/8ths of the tire was sticking out of either side, and unless I had a stout frame, chevy small block and some boggers, to me it just wouldnt look right..I am trying to build it lightweight...
(and just for reference, I used the same wheel/tire combo on the original axle as I did on my 44, so its not just the backspacing or anything)
 

·
Registered
Joined
·
2,641 Posts
Discussion Starter · #8 ·
guages, any one wanna trade for some gauges? Radiator? I need a lot of stuff.......
 
1 - 5 of 5 Posts
Top