Pirate 4x4 banner
1 - 3 of 3 Posts

· Registered
Joined
·
2,829 Posts
Discussion Starter · #1 ·
I have a Dana 70 front axle, closed knuckle with a six on 7" bolt pattern out of a dodge. What parts are interchangeable between a dana 60 and 70? Obviously the carrier, R&P, and such are not, but what about axleshafts, u-joints, bearings, seals, kingpin kits, etc. Please reply if you have any info or know where i could find part #'s. Thanks.
 

· Registered
Joined
·
631 Posts
I'm working on the same. I've found that Dana 60f wheel bearins fit the spindle but I cant find a hub off a 60f to measure bearing spacing.If the hub fits,i now have discs up front and just have to make a bracket for the caliper.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top