Pirate 4x4 banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,137 Posts
Discussion Starter #1
I need some ideas on how to change the perch angle on the housing side of a dana 60 king pin axle..I have searched but I only find how to change "C" angles..
 

·
Registered
Joined
·
376 Posts
or get the proper degree shims from just about any offroad vendor here and use one on TOP of the springs to keep the angles parallel. For instance, DIY4x sell's them in 3 piece sets specifically for the 60 to keep the load on the studs parallel...
 

·
Registered
Joined
·
1,137 Posts
Discussion Starter #5 (Edited)
thanks for the info...I guess I was looking for an easy way out but I mite as well do it right to begin with.my budy brian {general machine works} said he will mill it for me for a 18 pac
 
1 - 5 of 5 Posts
Top