Pirate 4x4 banner
1 - 2 of 2 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
I bought a set of 1 ton axles for my 91 K5 blazer and the perches are an inch off....3 of them look like a piece of cake to move ...the forth one is machined into the gearbox of the Dana 60 front end. Is there an easy way to fix this ? add a chunk of steel to the side of the housing?

Someone must have done this before!
 

·
Registered
Joined
·
59 Posts
Discussion Starter · #7 ·
just for the record....i remeasured in the daylight today and the D60 measured 32 to the perch centers. I then measured the Blazer springs to 31.5?....well we'll call it close enough.

the 14b ff measured 40.5 to the perch centers and the springs on the Blazer were hard to measure but it looked pretty close to 42".


Thanks for the help guys...didnt mean to wind you up LOL
 
1 - 2 of 2 Posts
Top