Pirate 4x4 banner
1 - 4 of 4 Posts

· Registered
Joined
·
484 Posts
Discussion Starter · #1 ·
After 30 min of searching Im having a hard time finding any info on how sharp a stock early 80's kingpin d60 knuckles can SAFELY turn without breaking a shaft , is there a measurement of how far out the steering stop bolt should be out of the knuckle or how many deg is safe ? Im adding hydro assist and want to limit the ram with out getting to the danger zone? In the past I have broke front axle shafts when turning but am unsure how to measure or tell when the u joint is binding

any info would be great
 

· Registered
Joined
·
480 Posts
Max steer angle = 40 degrees

After two minutes of searching. Found that in the bible.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top