Do what your gonna do but it not worth it. Its not hard to get the idler shaft and bearings out. at the very most its gonna take an hour to remove and install the shaft. if you get one little metal shaving in the wrong place, your going to have to do it all again.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Join the discussion
Pirate 4x4
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!
Full Forum Listing
Recommended Communities
Join now to ask and comment!