Pirate 4x4 banner
1 - 6 of 6 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
I've heard of putting a TJ front axle shaft into the passenger side of a YJ to bypass the vacuum mess. What else do you need to do? Put a seal down in the diff? Somewhere else in the tube?

Thanks!
 

·
Registered
Joined
·
99 Posts
somebody over on naxja did it in his XJ witha vac. disconnect on it. i think there was grinding on the inner housing to get a sal in there...look for 95.5 yj sahfts to get the 297x joint but still keep the vacum disconnect set up.

Hunter
 

·
Registered
Joined
·
4,719 Posts
Does the oil make it all the way to the vacuum disconect? On most all frontends the seal is just after the splines so no oil makes it into the tubes.
 

·
Registered
Joined
·
3,242 Posts
Yes the oil does go to the vac disco. Check "why switch to a 44" thread, it is discussed there.
 

·
Registered
Joined
·
4,719 Posts
have 60s so don't realy care but it is good info to know.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top