Did the lug nut pattern match that of your CJ? (5 on 5.5)
Dodge DANA 44
I've got the opportunity to get a DANA 44 front out of a 1976 Dodge truck. It has flat top knuckles. My question(s) are: Is this axles a good swap into my CJ7? It is already setup for SOA. Seems like it will be a good match to the Waggy 44 in the rear. Also, is it the same 5 lug bolt pattern as a jeep, or is it different?
Thanks for any feedback,
Thanks for any feedback,
1 - 3 of 9 Posts
J10 hub and spindle
Wondering if the J10 spindle and hub assembly will work on the Dodge axle?
Wondering if the J10 spindle and hub assembly will work on the Dodge axle?
1 - 3 of 9 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Pirate 4x4
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!
Full Forum Listing
Top Contributors this Month
View All
Wontun Splodies
60 Replies
total newb
59 Replies
NorCalJalopy
56 Replies
Recommended Communities
