Pirate 4x4 banner
1 - 2 of 2 Posts

· Registered
Joined
·
12,050 Posts
Discussion Starter · #1 ·
I just got my drill doctor and I was curious about the angle that I should be putting on my bits. should I stick with the standard 118 degree, or should I adjust up or down? I am drilling mainly through thicker steel(3/16 through 3/8)
 

· Registered
Joined
·
12,050 Posts
Discussion Starter · #4 ·
JonsYJjeep said:
Which model of the drill doctor did you get? I got the cheapo one. Model number 350 (i think) Only pain $60 for it at Lowe's. But I love that thing. Works great. But I didn't know you could adjust the angle.
I have the xp. I don't think you can adjust it on the 350
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top