Im running double u joint in the fornt of mine
Driveline?...
I have an '88 pickup with SAS 4" lift...I took my front driveline to Sac Driveline and had it extended...went to put it on and the cv does not allow enough angle for it to even bolt up...
Can I use a single joint from any driveline and have it give me enough angle even when my front droops? If so, does anybody have an extra front driveline 85' and below?
All I want is a front driveline!!!
And please don't pay attention to the posts below...they did not help...
BTW I already called Jess at High Angle and he said that a clearances CV in the front will only give 35 degrees...I need around 40 degrees
[ 08-30-2001: Message edited by: zesty_toy ]
[ 08-30-2001: Message edited by: zesty_toy ]
Can I use a single joint from any driveline and have it give me enough angle even when my front droops? If so, does anybody have an extra front driveline 85' and below?
All I want is a front driveline!!!
And please don't pay attention to the posts below...they did not help...
BTW I already called Jess at High Angle and he said that a clearances CV in the front will only give 35 degrees...I need around 40 degrees
[ 08-30-2001: Message edited by: zesty_toy ]
[ 08-30-2001: Message edited by: zesty_toy ]
1 - 2 of 8 Posts
once again, I said ......... Im running a u joint at both ends, you dont need a CV, Jess made my driveline.
1 - 2 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Pirate 4x4
A forum community dedicated to custom off-road vehicle owners and enthusiasts. Come join the discussion about trail reports, builds, performance, modifications, classifieds, troubleshooting, fabrication, drivetrain, and more!
Full Forum Listing
Top Contributors this Month
View All
Wontun Splodies
81 Replies
total newb
58 Replies
NorCalJalopy
45 Replies
Recommended Communities
