Pirate 4x4 banner
1 - 2 of 2 Posts

· Registered
510 Posts
Discussion Starter · #1 ·
If your steering geometry is set up right with the tie rod on top of the knuckles (for clearance and to compensate for lift)should you use I drop pitman arm or the stock one?

I have both to use, doing a hydro assist, tie rod on top of knuckle setup on a coil sprung 44 w.trac bar (I know I gotta make the tie rod and trac bar parallel for bumpsteer)
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.