Pirate 4x4 banner
1 - 7 of 7 Posts

·
Registered
Joined
·
534 Posts
Discussion Starter · #1 ·
OK, people, post up some pics of your solution.

After installing wider rear in the Runner and adjusting all the slack from the adjusting rod, I still lack about 1.25" - 1.5" on the cable. The shortside is on and I'm looking to finish it off.

What kind of contraptions are you using to connect the clevis end to the bellcrank?
 

·
Premium Member
Joined
·
3,030 Posts
I cut some elbows and welded them on to the stock lever. If you look at Opps pics, but imagine the extension angled up a little more and a little longer, I had to clear a 1.5" block. I made them from 1/8 plate.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top