Pirate 4x4 banner
1 - 1 of 1 Posts

·
Registered
Joined
·
141 Posts
There are a few ways to go about this. The first is free. You disconnect the driver side cable at the frame where it clips to the bracket just in front of the fuel filter. Drill a hole lower and reconnect.

Another way is to get a cable from a Jeep that uses a center console e-brake lever. The cables will be long and will work as a replacement for the driverside. Actually it will be a bit too long but it's not a problem. (I went this route since I had XJ cables from my D44 laying around.)

The passenger side isn't really an issue bur you can disconnect it from the body where it clips to the body above the driveshaft.
 
1 - 1 of 1 Posts
Top